Royston Handy Cap™ is easily applied and economical. It may be used on all anode lead wire and test wire weld areas. It is especially useful for welds on mill coated pipe where only a small part of the coating has been removed to permit installation of the thermite grounding connections. It is ideal for use in limited access situations, because it can be manipulated easily and applied at arm's length.
Installation is simple by following these steps:
Step 1 - Clean all mud, dirt, grease, oil and other contaminants from the metal surface and any part of the mill applied coating which is to be covered. Apply a coat of Royston Roybond 747 Primer and allow to dry to a non-glossy appearance, which will take about 5 minutes, depending on humidity and temperature.
Step 2 - Remove the release paper from the bottom of the Royston Handy Cap. Bend the plastic sheet inward at the serrations when applying to small diameter pipe. Position and place the Handy Cap on the welded area with the tunnel over the lead wire.
Step 3. Push the dome of the cap firmly into the weld area. Now lift the lead wire away from the pipe and squeeze the black rubber compound completely around and underneath the wire. Then push the lead wire back down on the pipe and press the elastomeric compound into firm contact with the pipe over the entire area.
No further protection is necessary when Royston Handy Cap covers the entire exposed metal area. Uncovered areas should be protected by applying tape or mastic, such as Royston Blue Max Water Pipe Line Tape CP or Royston Roskote Mastic.
When coating or wrapping the Royston Handy Cap, remove the narrow strips of plastic release film on the top of the cap. This will assure maximum protection by effecting a positive waterproof seal.
Construction |
Molded plastic cap filled with corrosion resistant compound on a base of thick elastomeric tape. |
|
---|---|---|
Dimensions |
Overall: |
4" x 4" |
Plastic sheet: |
2.75" x 4" (serrated) |
|
Sheet thickness: |
10 mils |
|
Plastic dome: |
1.625" dia, 0.8" height |
|
Adhesive thickness: |
165 mils |
|
Weight |
2.1 oz |
|
Application temperature |
-20 to +120°F |
|
Service temperature |
-40 to + 185°F |
|
Shelf life |
Rotate annually |
Royston Handy Cap™ is packaged 20 per carton. Shipping weight is 5 lbs.
Royston Roybond 747 Primer is available in: