By continuing to browse this website or by clicking 'I Accept', you agree to the use of cookies. Cookies are stored on your computer or mobile device and enhance your site experience. To learn more about how we use cookies, you can click the 'Learn More' button.
Link-Seal Modular Seals Sizing Procedure 1 Using Charts for Standard Pipes
Method 1 - Using Sizing Charts
Link-Seal Modular Seal Sizing Using Charts (if your pipe type and size matches with standard pipe charts)
From the links below, find the one that applies to your pipe type and locate correct pipe size (Nominal Diameter & Actual Outside Diameter). Verify that your pipe O.D. matches the actual outside diameter shown on the chart.
Determine the type of wall opening to be used: Century-Line® non-metallic (CS Model Sleeve), WS Steel Sleeve or Cast/Core Drilled Hole.
Begin at column heading “Pipe Size - Nominal”. Read across to the sizing section for your sleeve type and wall opening Century-Line® (CS Model Sleeve), WS Steel Sleeve or Cast/Core Drilled. The first column identifies the sleeve model or hole diameter...the second column identifies the Link-Seal modular seal size... and the third column provides the number of links required for a complete seal assembly.
Determine the best Link-Seal modular seal Model for your application.
Century-Line Non-Metallic Sleeve or WS Steel Sleeve Sizing (if your pipe type and size matches with standard pipe charts)
When ordering Link-Seal® modular seals, note sleeve part numbers in columns CS Model Number (Century-Line®) or WS Model Number and indicate sleeve length in inches.
Note: Century-Line® sleeves are shipped standard in 16” lengths and can be field cut to as short as 8” in length. Please see page 23 for installation techniques.
Cell-Cast Hole Forming Disk Sizing (if your pipe type and size matches with standard pipe charts).
When ordering Cell-Cast Disks, note the CC Model Number and combine 3” or 4” Cell-Cast Disks to create wall thickness. Please see installation techniques.
Note: Contact Corrosion Control Products Company if your pipe sizing solution is not listed in the provided charts.
When ordering Link-Seal® modular seals, note sleeve part numbers in columns CS Model Number (Century-Line®) or WS Model Number and indicate sleeve length in inches.
When ordering Cell-Cast Disks, note the CC Model Number and combine 3” or 4” Cell-Cast Disks to create wall thickness. Please see installation techniques.
