Non-Pressure Pipe, Joint & Crack Repair Kits By Neptune Research, Inc.

Repairs broken or cracked pipes and joints. Ready to use, heat resistant, no mixing, no mess, sets rock hard in minutes
  •  

     

    Product Information

    Syntho-Glass® repairs broken or cracked pipes damaged through everyday wear or when an unexpected emergency occurs. It is patented and easy to use for quick action.


    Typical Applications
    Non-pressure repair and protection for:

    • Cracked piping
    • Leaking joints
    • Corroded pipes
    • Emergency repair
    • Potable waterlines
    • Irregular pipe fittings

    Benefits

    • Ready to use
    • Heat resistant
    • Effective time saving
    • No mixing & no mess
    • Sets rock hard
    • NSF61 approved

    Repair Kit Contents

    • Syntho-Glass®
    • Butyl Patch
    • Syntho-Steel™ Putty
    • Gloves
    • Instructions

    Properties
     

    Physical Properties

    Resistance Temperature to Heat
    Resistance Temperature to Cold
    Gasoline & Oil
    Alcohol
    Water
    Low Concentration Mineral Acid
    High Concentration Mineral Acid
    High Concentration Alkali
    Low Concentration Alkali

    300°F
    -50°F
    OK
    OK
    OK
    OK
    OK
    OK
    OK

    Mechanical Properties

    Tensile Strength
    Lap Shear Strenght
    Flexural Strength
    Dielectric Strength

    38,000 psi     
    900 psi     
    18,000 psi     
    16,000 volts    

     

  • Preparation & Application
    (Maximum pressure use of UP kit is 60 psi)
    Installation Guide in pdf Format
    1a. Joint / Potable water systems: Knead putty until uniform in color. Roll into a rope or ball. Place firmly into joint or crack. Feather edges with wet finger.
    1b. Crack: Remove adhesive backing from Butyl Patch and apply directly over break; press firmly onto pipe.
    2. Remove Syntho-Glass® from foil pouch using enclosed gloves. Soak in temperate water for 20 seconds.
    3. Tightly wrap Syntho-Glass using entire roll. Wrap approximately 2” above and below the repair and directly over the rubber tape.
    4. Squeeze and mold Syntho-Glass in the direction of wrap, removing excess water and spreading resin until tacky to touch (approximately 3-5 min.). Allow 30 minutes at 75°F before re-applying water pressure.
  • Ordering Information
    Pipe Diameter Roll Size Kit #
    1/2" - 1"
    1-1/4" - 2"
    2-1/2" - 4"
    4-1/2" - 6"
    2" x 5"
    3" x 9'
    4" x 15'
    4" x 30'
    NP520
    NP930
    NP415
    NP430