Moldable Sealant for Irregular Surfaces by Tapecoat
- SKU#: Tapecoat Moldable Sealant for Irregular Surfaces
- Watertight, conformable coating for corrosion protection of irregular surfaces.
-
Basic Use
Tapecoat Moldable Sealant is a conformable water tight coating for irregular surfaces, such as bolt style mechanical couplings, bell and spigot joints, saddle tees or leak clamps; as a sealant in vaults, on underground tracer wire and other low voltage manual wire connections, on anode wire connections, as an insulating adhesive with shrinkable tubing.
Composition
Tapecoat Moldable Sealant is a 100% solids formulation of thermoplastic elastomeric and synthetic resins. Blended in this adhesive is an “integrated primer.”
-
Technical Data
Color
Gray
Service temperature
-30ºF to 120ºF (-35ºC to 40ºC)
Application temperature
Above -10ºF (-23ºC)
Total thickness
40 and 60 mils (1.0 and 1.5 mm)
Adhesion
165 oz/inch width
Flexibility
1/2" radius at -20ºF without cracking
Dielectric strength
> 12 kV
Cathodic disbonding
Pass (ASTM G-8)
Insulation resistance
108 megohms
Water absorption
< 0.05%
Application
Surface Preparation
Surface must be clean and dry. Moisture, dust, dirt, rust or other foreign matter should be removed by scraping or wire brushing. Remove oil and grease, etc, with suitable detergent. Optional cleaning method SSPC 6 Commercial Blast.
Application
- Priming: Because TC-Moldable Sealant comes with an "integrated primer" built into the adhesive, liquid primer may not be required. TC Omniprime Primer has been developed specifically for use with Moldable Sealant. The coverage is approximately 300 square feet per gallon. Let TC Omniprime dry to a tacky consistency before applying Moldable Sealant.
- Sealant Application: Remove the release liner on one side of the moldable sealant and apply to the surface to be protected. Remove the remaining liner and use it as an aid in molding the sealant until all voids and crevasses have been filled. Liner may then be used as an overwrap for additional mechanical protection.
Technical Service
Contact Corrosion Control Products Company.
- Priming: Because TC-Moldable Sealant comes with an "integrated primer" built into the adhesive, liquid primer may not be required. TC Omniprime Primer has been developed specifically for use with Moldable Sealant. The coverage is approximately 300 square feet per gallon. Let TC Omniprime dry to a tacky consistency before applying Moldable Sealant.